Transport Operation; Inspection And Cleanup After Mowing - Toro 04351 Greensmaster 3050 Operator's Manual

3
Figure 26
1. Alignment strip
2. Approximately 5 in.
(12.7 cm)
3. Cut grass on left
5. Cut down on operating time and ease lineup for the next
pass by momentarily turning the machine in the
opposite direction, then turning in the direction of the
uncut portion; i.e., if intending to turn right, first swing
slightly left, then right. This will assist in getting the
machine more quickly aligned for the next pass. Follow
the same procedure for turning in the opposite direction.
It is a good practice to try to make as short of a turn as
possible. However, turn in a wider arc during warmer
weather to minimize the possibility of bruising the turf.
Important The machine should never be stopped on a
green with the cutting unit reels operating as damage to the
turf may result. Stopping on a wet green with the machine
may leave marks or indentations from the wheels.
6. Finish cutting the green by mowing the outer periphery.
Be sure to change the direction of cutting from the
previous mowing. Always keep weather and turf
conditions in mind and be sure to change the direction
of mowing from the previous cutting. Replace the flag.
7. Raise the cutting units and empty the grass baskets of
all clippings before transporting to the next green.
Heavy wet clippings place an undue strain on the
baskets and will add unnecessary weight to the
machine, thereby increasing the load on the engine,
hydraulic system, brakes, etc.
4
2
1
4. Keep focal spot 6–10 ft.
(1.8–3 m) ahead of the
machine.

Transport Operation

Make sure that the cutting units are in the full up position.
Set the shift selector in No. 2 if conditions will permit
faster ground speed. Shift to No. 1 and operate at slower
ground speeds in rough or hilly areas. Use the brakes to
slow the machine while going down steep hills to avoid
loss of control. Always approach rough areas at a reduced
speed (shift selector in No. 1), and cross severe undulations
carefully. Familiarize yourself with the width of the
machine. Do not attempt to pass between objects that are
close together so that costly damage and down time can be
prevented.
Inspection and Cleanup After
Mowing
At the completion of the mowing operation, thoroughly
wash the machine with a garden hose without a nozzle so
excessive water pressure will not cause contamination and
damage to the seals and bearings. After cleaning, it is
recommended the machine be inspected for possible
hydraulic fluid leaks, damage or wear to hydraulic and
mechanical components, and the cutting units checked for
sharpness. Also, lubricate the mow and lift pedal and brake
shaft assembly with SAE 30 oil or spray lubricant to deter
corrosion and help keep the machine performing
satisfactorily during the next mowing operation.
25