KTM 250 SX-F EU Setup Instructions page 8

WORK
Installing the front fender
3.4
Installing the start number plate
3.5
Opening filler cap
3.6
Closing filler cap
3.7
Refueling
3.8
Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact of the fuel with skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate or headlight
mask.
600692-10
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and wiring harness. Put the clamp on, mount and tighten
screw .

500101-11
–
Press release button
remove.
400199-10
–
Replace the filler cap and turn clockwise until the release button
Info
Route the fuel tank breather hose
400199-11
M6
M6
, turn filler cap counterclockwise and lift it upwards and

without kinking.

.

10 Nm (7.4 lbf ft)
with the spacer.

10 Nm (7.4 lbf ft)
locks in place.

6