KTM 250 SX-F EU Setup Instructions page 5

SET‑UP
Unpacking and setting up the vehicle
2.1
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during assembly, leave the protective
plastic on the vehicle until you have finished.
–
Remove the separate enclosure and unpack it. Check that the scope of delivery is
complete on the basis of the enclosed packing list.
–
Set up the work stand.
600821-10
Work stand (54829055000)
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a work stand.
–
Check the vehicle for transport damage.
–
Mount the handlebar.
The scale on the handlebar should be in the center of the handlebar clamp.
–
Position the handlebar clamp. Mount and evenly tighten the four screws.
Guideline
Screw, handlebar clamp
600824-10
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables and throttle cables can be seen in the figure.
600822-10
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. (
–
Correctly mount the fuel tank breather.
–
Install the start number plate. (
–
Install the front wheel. (
600823-10
M8
p. 6)
p. 6)
p. 5)
3
20 Nm
(14.8 lbf ft)