Advertisement
XL-R910SL
Removing the power button arm (See Fig.6)
* Prior to performing the following procedure,
remove the metal cover and front panel assembly.
The power button arm is lifted up while holding the
power switch(orange color part) and removes.
Removing the mechanism assembly
* Prior to performing the following procedure,
remove the metal cover and front panel
assembly.
1.Disconnect the card wire from connector CN501
on the servo control board.
2.Disconnect the 6pin wire from connector CN701
on the servo control board.
3.Remove the four screws D attaching the
mechanism assembly.
*Please fix two earth wires together when you
install the mechanism assembly.
Removing the main board (See Fig.5,7)
* Prior to performing the following procedure,
remove the metal cover.
1.Remove the four screws E attaching the each
terminal on the rear panel.
2.Disconnect the 9pin,8pin and 3pin wire from
connector RCW1,RCW2 and ACW1 on the main
board.
3.Disconnect the card wire from connector NCW1
on the main board.
4.Disconnect the 6pin wire from connector CN701
on the servo control board.
5.Remove the screw D attaching the earth wire.
6.Remove the two screws F and one screw G
attaching the main board.
Please remove a tie band if necessary.
Please fix the wire again with a tie band
when assembling.
1-4
RCW1
(See Fig.6)
Tie band
Orange
color part
Power
button
arm
RCW2
F
F
Mechanism
assembly
D
Earth wire
Mechanism
assembly
D
D
E
E
E
E
Fig. 7
ACW1
Main board
G
NCW1
CN502
Tie band
CN701
CN601
Fig. 5
Main board
D
CN501
Earth wire
CN701
D
Fig. 6
Cord bushing
Advertisement
