Advertisement
Disassembly method
<Main body>
Removing the metal cover (See Fig.1)
1.Remove the three screws A attaching the metal cover
on the back of the body.
2.Remove the four screws B attaching the metal cover
on both sides of the body.
3.Remove the metal cover from the body by lifting the
rear part of the cover.
ATTENTION : Do not break the front panel tab fitted
to the metal cover.
Removing the front panel assembly (See Fig.2~5)
* Prior to performing the following procedure, remove the
metal cover.
1.Remove the three screws C attaching the front panel
assembly on the bottom of the body and both sides of
the body.
2.Disconnect the card wire from connector CN601 on the
servo control board.
3.Disconnect the 4pin wire from connector CN502 on the
servo control board.
4.Disconnect the 3pin wire and 8pin wire from connector
ACW1 and RCW2 on the main board.
Please remove a tie band if necessary.
Please fix the wire again with a tie band when assembling.
5.Release the two joints a on the lower part of the sides
using a screwdriver, and remove the front panel assembly
toward the front.
F
RCW1
F
Tie band
D
RCW2
ACW1
Main board
G
NCW1
Mechanism
assembly
CN502
CN701
CN601
Fig. 5
Metal cover
B x 2
Front panel assembly
Front panel assembly
Joint a
Tie band
B x 2
A
Fig. 1
C
Fig. 2
Front panel assembly
joint a
C
Fig. 3
C
Fig. 4
XL-R910SL
A
A
1-3
Advertisement
