Kenwood DDX6034 Service Manual page 19

Up/Down (Green)
: Green Offset key. (This key is displayed only
when the Green Offset mode is turned ON)
Up/Down (Blue)
: Blue Offset key. (This key is displayed only
when the Blue Offset mode is turned ON)
Up/Down (Yellow)
: Yellow Offset key. (This key is displayed only
when the Yellow Offset mode is turned ON)
Direct Adjustment bar
: Right and Left Adjustment.
DW / UP : Right and Left Adjustment. (for Fine Adjust-
ment)
Return : Transfer to Test Mode Main screen.
* Select black for the background color until "Write OK/NG"
is displayed.
Modify the background color to blue at the same time as
"Write OK" is displayed.
Modify the background color to red at the same time as
"Write NG" is displayed.
2.3.10. iPod Authentication Chip Confi rmation screen
Check communication for iPod authentication.
The iPod Authentication Chip Confirmation screen is dis-
played in Figure 2.3.10.
iPod Check
iPod Check
Cancel
Figure 2.3.10 iPod Authentication Chip Confi rmation screen
Key Specifi cation
iPod Check : Start checking communication for iPod au-
thentication.
Cancel : Transfer to Test Mode Main screen.
Return : Transfer to Test Mode Main screen.
* Select black for the background color until "iPod OK/NG"
is displayed.
Modify the background color to blue at the same time as
"iPod OK" is displayed.
Modify the background color to red at the same time as
"iPod NG" is displayed.
TEST MODE
iPod Check
iPod OK/NG
Return
DDX6034/6034M/6054/7034BT/7034BTM/714
DNX7000EX/7140/7240BT/7340BT
2.3.11. LCD Adjustment screen
This screen is used to perform adjustment of LCD.
The displayed contents of the LCD Adjustment screen is
displayed in Figure 2.3.11.
LCD Auto Adjust
All Auto Flicker
W.B. Auto AGC Auto
VCOM Auto HPOSI Auto
Cancel
Make a space.
(The production process mainly uses
the above-mentioned two keys.)
Figure 2.3.11 LCD Adjustment screen
Key Specifi cation
All Auto : Start Auto Adjustment. (The following four
Auto adjustments are executed continu-
ously)
W.B. Auto : Start the W.B. Auto adjustment.
AGC Auto : Start the AGC Auto adjustment.
VCOM Auto : Start the VCOM Auto adjustment.
HPOSI Auto : Start the HPOSI Auto adjustment.
Flicker : Transfer to the Flicker Adjustment screen.
Cancel : Transfer to Test Mode Main screen.
Return : Transfer to Test Mode Main screen.
* Select black for the background color until "Write OK/NG"
is displayed.
Modify the background color to blue at the same time as
"Write OK" is displayed.
Modify the background color to red at the same time as
"Write NG" is displayed.
2.3.12. Flicker Adjustment screen
This screen is used to perform adjustment of the Flicker.
Transfer to this screen also when Tenkey0 on the remote
controller is pressed.
The displayed contents of the Flicker Adjustment screen are
displayed in Figure 2.3.12.
Figure 2.3.12 Flicker Adjustment screen
LCD Auto Adjust
Write OK/NG
Return
Flicker Adjust
Write OK/NG
Return
19