Coffee Quantity; Pre-Injection; Percolation Time; Percolation Temperature - BOMANN CB 2001 Instruction Manual

Coffee Quantity

• Call up the menu item „coffee quantity". The coffee
bean symbol fl ashes.
• Change the coffee quantity with the
button.
• Save the changes with the MENU/OK/MEMORY
button.

Pre-Injection

grinding and your personal taste. A larger pre-injection
quantity should be selected for a fi ne degree of grinding.
The "normal pre-injection quantity" setting is shown in
the display by 2 arrowheads in the middle. In the "small
pre-injection quantity" setting the arrowheads are on the
left, while in the "large pre-injection quantity" setting they
are on the right.
• Call up the menu item „pre-injection quantity". The
coffee powder symbol fl ashes.
• Change the pre-injection quantity with the
buttons.
• Save the changes with the MENU/OK/MEMORY
button.

Percolation Time

• Go to the „percolation time" menu item. The coffee bean
and the coffee powder symbols fl ash simultaneously.
• Change the percolation time with the
buttons.
• Save the changes with the MENU/OK/MEMORY
button.
05-KAV 2936 GB 21
You can make your coffee
with a small, normal or
large quantity of coffee.
The "normal" setting is
shown in the display by
2 arrowheads in the midd-
le. If the small quantity
of coffee has been set
the arrowheads are on
the left, while in the large
quantity coffee setting
they are on the right.
or
Before percolation
the coffee powder is
moistened slightly and
swells up. This allows the
aroma to unfold better.
You can select between
a normal, small and large
pre-injection quantity.
The best setting depends
on the sort of coffee
being used, the degree of
or
You can choose between a
normal, short or long per-
colation time. The "normal"
setting is shown in the
display by 2 arrowheads
in the middle. In the "short
percolation time" setting
the arrowheads are on
the left, while in the "long
percolation time" setting
they are on the right.
or

Percolation Temperature

• Call up the „percolation temperature" menu item. The
steam symbol fl ashes.
• Change the percolation temperature with the
or buttons.
• Store the changes with the MENU/OK/MEMORY
button.

Energy-Saving Mode

any button. The fl ashing symbols go off. As soon as the
MENU/OK/MEMORY button stops fl ashing the machine
can be used again.
A period of between 15 minutes and 11 hours and 45
minutes can be set. The preset is 1 hour.
• Go to the „energy-saving mode" menu item. The
coffee powder and steam symbols fl ash.
• Press the button to increase the set time by
15 minutes in each case.
• Press the button to reduce the set time by 15
minutes in each case. The set time is displayed by
arrowhead pairs.
The horizontal arrows show the minutes. Press as
follows:
pressing once = 15 minutes,
pressing twice = 30 minutes,
pressing three times = 45 minutes.
If you press a fourth time a vertical arrow appears in
the display. The full hour has been reached. If you
press the button again the „15 minute arrow" reap-
pears in the horizontal position, then the „30 minute
arrow" etc. in the example shown at the side a period
of 2 1/2 hours would be set.
• Save the changes with the MENU/OK/MEMORY
button.
You can choose between
a normal, low and high
percolation temperature.
The "normal" setting is
shown in the display by 2
arrowheads in the middle.
In the "low percolation
temperature" setting the
arrowheads are on the
left, while in the "high
percolation temperature"
setting they are on the
right. The preset is "high".
If the machine is not used
for a certain period it swit-
ches to the energy-saving
mode. This is shown by
the "coffee powder" and
the "steam" symbols
fl ashing. In the energy-sa-
ving mode the cup shelf
heating is switched off.
The energy-saving mode
is interrupted by pressing
21
03.12.2004, 12:13:27 Uhr