Table of Contents
Advertisement
Plug-In Units
Plug-in units can be removed.
Lift a plug-in unit about 1" above
the drip pin—just enough to grasp
it—and you can pull it out.
Do not lift a
l". If you do, it may not lie
than
flat on the drip pan when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1" above the drip
pan can permanently damage
the receptacle.
To replace a plug-in unit:
The drip pan must be placed into
the surface cavity first. Make sure
the opening in the drip pan lines up
with the receptacle.
Insert the terminals of the plug-in
unit through the opening in the
drip pan and into the receptacle.
Guide the surface unit into place
so it fits evenly in the drip pan.
22
(continued)
CAUTION
Do not attempt to clean plug-in
surface units in an automatic-
dishwasher.
Do not immerse plug-in surface
units in liquids of any kind.
Do not bend the plug-in surface
unit plug terminals.
Do not attempt to clean, adjust or
in any way repair the plug-in
receptacle.
Adjusting Oven
Thermostat
The temperature control in your
new oven has been carefully
adjusted to provide accurate
temperatures. However, if this
oven has replaced one you have
used for several years, you may
notice a difference in the degree of
browning or the length of time
required when using your favorite
recipes because oven temperature
controls have a tendency to "drift"
over a period of years.
Before attempting to have the
temperature of y~ur new oven
changed, be sure you have
followed the baking time and
temperature of the recipe carefully.
a few times and you feel the oven
is too hot or too cool, there is a
simple adjustment you can
make yourself on the OVEN
Note position of
pointer to marks
before adjustment
1. Pull the knob off the shaft and
look at the back side. There is a
disc in the center of the knob skirt
with a series of marks opposite
a pointer.
Note to which mark the pointer is
pointing. To make an adjustment,
carefully loosen (approximately
one turn), but do not completely
remove the two screws that
the skirt to the knob. Hold the
knob blade in one hand and the
outer skirt in the other hand.
2. To raise the oven temperature,
move the pointer in the direction
of the arrow for RAISE. To lower
the temperature, move the pointer
in the direction of the arrow for
LOWER. Each mark will change
the oven temperature approximately
the adjustment one mark
original setting and check oven
performance before making any
additional adjustments.
3. After the adjustment is made,
press skirt and knob together and
but be careful not to overti~hten.
Reinstall knob on range and
check performance. Be sure to
match "D" shaft on knob to stem
when re~lacinz.
NOTE: After an adjustment has
been made to the OVEN TEMP
knob, OFF and BROIL will not
line up with the indicator mark on
the control panel as they previously
did. This condition is normal and
will not create a problem.
Loosen only
. the locking
screws
the
.
Advertisement
Table of Contents
