Operating Tips - Toro 31101 Groundsmaster 360 Operator's Manual

1. U-bolt
1. Left rear lift chain
Leveling Side to Side
If the cut is uneven across the mower swath, correct it as
follows:
1. Position the machine on a level surface on the shop
floor
2. Set the cutting unit to the desired height of cut, move
the throttle lever to the Slow position, stop the engine,
set the parking brake, and remove the ignition key.
3. Check and adjust front and rear tractor tire pressure;
refer to Checking Tire Pressure.
4. Check for bent blades.
5. Remove the covers from the top of the cutting units
Figure 6
2. Jam nut
Figure 7
2. Right rear lift chain
6. Rotate the blade on each spindle until the ends face
forward and backward.
7. Measure from the floor to the front tip of the cutting
edge
8. Adjust the jam nuts securing the deck chains to the
mower deck until the mower deck is level (Figure 7).

Operating Tips

Folding Castor Arm
To gain access to or from the operator area when the wing
decks are folded up, release the castor arm latch (Figure 8)
and rotate the castor arm away from the traction unit.
1. Castor arm latch
Important: Make sure to rotate the castor arm back to
the traction unit before mowing.
Transport Latches
Before transporting the machine, raise the cutting units and
secure the wing deck transport latches (Figure 9).
1. Wing deck transport latches
10
Figure 8
Figure 9