Toro 20314 Operator's Manual

20in Mulching/Rear Bagging Lawn Mower
Model No. 20314—Serial No. 311000001 and Up
Introduction
This rotary-blade, walk-behind lawn mower is
intended to be used by residential homeowners
or professional, hired operators. It is designed
primarily for cutting grass on well-maintained lawns
on residential or commercial properties. It is not
designed for cutting brush or for agricultural uses.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Figure 1
1. Model and serial number plate
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
© 2010—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
1. Safety alert symbol
This manual uses two words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
This spark ignition system complies with Canadian
ICES-002.
The enclosed Engine Owner's Manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California
Emission Control Regulation of emission systems,
maintenance, and warranty. Replacements may be
ordered through the engine manufacturer.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the
engine manufacturer in accordance with SAE J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine horsepower on this class
of lawn mower will be significantly lower.
Do not tamper with the engine controls or alter the
governor speed; doing so may create an unsafe condition
resulting in personal injury.
Safety
This lawn mower meets or exceeds the CPSC blade
safety requirements for walk-behind rotary lawn mowers
and the B71.1 specifications of the American National
Standards Institute in effect at the time of production.
Read and understand the contents of this manual
before you start the engine.
The safety alert symbol (Figure 2) is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury
or death. Improperly using or maintaining this mower
could result in injury or death. To reduce this potential,
comply with the following safety instructions.
Register at www.Toro.com.
Form No. 3367-809 Rev A
Operator's Manual
Figure 2
Original Instructions (EN)
Printed in the USA
All Rights Reserved