Table of Contents
Advertisement
the bracket should be rotated to the left 10 degrees
from vertical (Figure 4).
2. On lift arms #2 and #3, position the brackets and
U-bolts 15 inches behind the center line of the pivot
knuckle (Figure 5). Rotate the brackets 45 degrees to
the outboard side of the machine.
3. On lift arms #6 and #7, position the brackets and
U-bolts 14.5 inches behind the center line of the
pivot knuckle (Figure 6). Rotate the brackets 10
degrees to the outboard side of the machine.
Figure 4
Figure 5
4. Tighten all the U-bolt nuts to 38–48 ft-lbs.
5. Mount a lift chain to each chain bracket with a screw,
washer and nut, positioning as shown in Figure 7
1. Lift chain
4
Cutting Unit Kickstand
Parts needed for this procedure:
1
Kickstand (supplied with traction unit)
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with
the kickstand (supplied with the traction unit) to make
6
Figure 6
Figure 7
2. Chain bracket
Advertisement
Table of Contents
