Data Bits - ID Tech RS-232 User Manual

5. Type the one-character code for the change you wish to make.
6. Press <ENTER>. The reader should beep twice.
7. Save the setting and exit the Group Setup Mode by typing EZ.
8. Press <ENTER>. The reader should beep four times.
Baud Rate
The baud rate is the speed at which data is transmitted and received.
SELECTION CODE: E1
300 bps
1200 bps
2400 bps
4800 bps
9600 bps
19200 bps

Data Bits

Set the number of data bits used to define a character.
SELECTION CODE: E2
7 bits
8 bits
Parity
Serial communication can define a parity check bit to be added to each
character. This check bit can be true for an odd number of "1" bits or an even
number of "1" bits in the data character. The user may also choose to define
the parity bit as a MARK (true) or a SPACE (false). Selecting NONE results
in no parity bit.
SELECTION CODE: E3
Odd
Even
Mark
Space
None
Note: The reader must use a total of 10 or 11 bits to define a character frame.
If you select "7" data bits with the "None" parity option, the reader will for-
mat the character frame as 8 data bits and no parity.
A
C
D
E
F
G
A
B
A
B
C
D
E
6