Ricoh G031 Service Manual page 175

Tray Installation Error
Message:
Install Tray XX
Definition:
Tray XX is not installed correctly.
Reset Method:
Set the tray correctly.
Paper End
Message:
Tray XX: Add Paper
Definition:
Paper has run out in tray XX.
Reset Method:
Load paper.
Paper Tray Error
Message:
• Load Tray XX: {paper size}
• Load Bypass Tray: {paper size}
Definition:
• Tray XX (or the by-pass tray) is empty.
• The actual size of paper loaded in tray XX (or the by-pass tray) does not
match the size for which the page was created.
Reset Method:
Load paper of the correct size in the specified feed direction into tray XX (or the
by-pass tray), and print automatically. If not, check that the paper size setting in
the tray is correct.
NOTE: 1) When "Auto Select" is specified for the paper source using the printer
driver, this message might appear when there is paper of the correct
size but in the different feed direction in any of the trays.
2) The page is printed on the incorrect paper size in tray XX (or the by-
pass tray) in the following cases.
a) If you press "Enter" without loading the correct paper.
b) If a specified period of time has passed with the Auto Continue
feature on. (Auto Continue does not work if this error exists.) If that
happens, you cannot continue printing if there is a paper size error.
You should take one of the following actions to clear this error.
• Press "Enter".
• Open and close any of the trays.
SM
OPERATOR ERRORS
7-3 G031/G032