Fuses; Servicing The Battery - Toro Groundsmaster 328-D 30630 Operator's Manual

Traction unit
Table of Contents

Advertisement

with jack stands.
3.
Clean the area around the hydraulic oil filter and
remove the filter.
4.
Remove drain plug from the fitting between axle
housing and oil filter and let the oil flow into a
drain pan (Fig. 49).
Figure 49
1. Drain plug
5.
Install a new filter; refer to steps 1–2 in
Replacing Hydraulic Oil Filter, page 14, for
proper procedures.
6.
Install the drain plug in the fitting between the
axle housing and oil filter (Fig. 49).
7.
Remove the dipstick from the axle filler tube
(Fig. 50) and fill the axle to proper level with
correct type and viscosity oil recommended for
expected ambient temperature conditions; refer to
table above.
8.
Start and run the engine at idle speed for about
two minutes and turn the steering wheel lock to
lock to purge air trapped in the system. Shut the
engine off.
9.
Let the machine sit for two additional minutes,
then remove the dipstick and check the oil level
in axle (Fig. 50). If the level is low, add oil until
the level matches the groove in the dipstick (Fig.
50). If the level is too high, remove the drain
plug (Fig. 49) and drain oil until the oil level
matches the groove in the dipstick.
1
37
Figure 50
1. Dipstick
2. Groove

Fuses

There are 3 fuses in the machine's electrical system,
located below control panel.
1
Figure 51
1. Fuse block

Servicing the Battery

WARNING
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California to
cause cancer and reproductive harm. Wash
your hands after handling.
Important
Before welding on the machine,
disconnect the ground cable from the battery to
prevent damage to the electrical system.
Note: Check battery condition weekly or after every
50 hours of operation. Keep the terminals and battery
case clean because a dirty battery will discharge
slowly. To clean the battery, wash the entire case with
solution of baking soda and water. Rinse with clear
water. Coat the battery posts and cable connectors
1
2

Advertisement

Table of Contents
loading

Table of Contents