Adjusting The Handle Height - Toro 30682 Operator's Manual

Figure 12
1. Latch pin
2. Spacer, 3/16 inch (5 mm)
2. Remove the latch pin, slide the caster from the
support, and change the spacers (Figure 12).
3. Install the caster in the support and insert the latch
pin (Figure 12).

Adjusting the Handle Height

The handle position can be adjusted to match the
operator's height preference.
1. Remove the hairpin cotter pins and clevis pins from
the drive levers and neutral locks (Figure 13).
Figure 13
1. Control rod
2. Clevis pin
3. Operator Presence
Control lever (OPC)
4. Handle
2. Loosen the upper bolts (3/8 x 1-1/4 inches) and
flange nut securing handle to rear frame (Figure 14).
3. Spacer, 1/2 inch (13 mm)
5. Neutral lock
6. Hairpin cotter pin
7. Left handle shown
8. Drive lever
3. Remove the lower bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Figure 14).
4. Pivot the handle to the desired operating position
and install the lower flange bolts (3/8 x 1 inch)and
flange nuts into the mounting holes. Tighten all
flange bolts.
1. Upper handle
2. Rear frame
3. Flange bolt (3/8 x 1 inch)
4. Lock nut (3/8 inch)
5. Upper mounting hole
5. Adjust the control rod length by rotating the control
rod in the rod fitting (Figure 13).
6. Install a hairpin cotter between the drive levers and
neutral locks and into the clevis pins (Figure 13).
Note: Make sure the clevis pins are inserted into
the neutral locks.
7. Check the parking brake adjustment. Refer to
Checking the Brakes in Brake Maintenance ,
page 31.
20
Figure 14
6. Lower mounting holes
7. Low position
8. Middle position
9. High position