Setup; Checking The Fluids And Tire Pressure; Reading The Manual And Viewing The Safety Information - Toro 30682 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Note: Determine the left and right sides of the machine from the normal operating position.
1
Checking the Fluids and Tire
Pressure
No Parts Required
Procedure
• Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Engine Oil Level.
• Check the grease for the mower and mower deck.
• Check the tire pressure; refer to Checking the Tire
Pressure.
Description
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
Safety Video/DVD
Registration Card
Oil drain hose
Qty.
–
Check the fluids and tire pressure.
1
1
1
Read the Operator's Manual and watch
the video before operating the machine.
1
1
1
2
Reading the Manual and
Viewing the Safety Information
Parts needed for this procedure:
1 Operator's Manual
1 Engine Operator's Manual
1 Parts Catalog
1 Safety Video/DVD
1 Registration Card
1 Oil drain hose
Procedure
• Read the Operator's Manual.
• View the safety video.
• Fill out the registration card and mail it in or register
online at www.Toro.com.
• Use the oil drain hose when changing the engine oil.
Note: The cutting blades are set to a 3 inch (76mm)
height-of-cut at initial purchase. The axle position is D,
with 4 spacers below both the spindle and the caster.
11
Use