S-Vhs (Supervhs) And S-Vhs Et Recording; To Record In S-Vhs Mode - Toshiba W808 Service Manual

RECORDING
S-VHS (Super VHS) and S-VHS ET Recording
S-VHS allows you to make high quality video recordings with a horizontal resolution of 400 lines
compared with 240 lines of resolution of normal VHS recordings.
3
1 2 3
4 5 6
7 8 9
0 100
I.SELECT
4
PLAY/x2
REW FF
ENTER
6
STOP
5
DNR
VCR Plus+
REMAIN COUNT
A.SELECT
COUNTER RESET
2
POWER CH DOWN CH UP
To record from other
connected equipment
In step 3, press I.SELECT to
switch the display as follows:
LI: To record via the LINE IN
1 jacks or the LINE IN 1 S-
VIDEO jack on the rear panel.
L2: To record via the LINE IN
2 jacks or LINE IN 2 S-VIDEO
jack on the front panel.
S-VIDEO jack will be selected
if both LINE IN and S-VIDEO
jacks are connected.
28

To Record in S-VHS Mode

Cassette marked with "S-VHS" should be used.
1
Load a cassette with the safety tab attached.
The " " indicator will appear on the VCR display when the S-
VHS tape is loaded.
2
Press TV/VCR so that the "VCR"
indicator appears in the VCR display.
3
Select a channel to record with
CHANNEL on the VCR, or CH/TRK
or number buttons on the remote
control.
If you see "L1" or "L2" in the VCR display, press I.SELECT so that the
channel number appears.
• If you record cable channels via the cable box, make the output
channel number of the cable box or "L1" appear, depending on your
connection. (See pages 11 – 13.)
4
Press SP/SLP to select the
recording tape speed.
SP: Suitable for general recording with
better picture and sound quality.
SLP: Suitable for tripling recording time, but with less picture and
sound quality than using the SP tape speed.
5
Press PROG. to display the MENU screen.
6
Select "SET UP" using FF or REW , and press ENTER .
7
Press STOP repeatedly to go to screen 2 of SET UP page to
select "S-VHS REC", and set to "ON" using REW or FF .
" " indicator will appear on VCR display when
8
Press REC on the VCR, or
simultaneously press both REC on
the remote control.
The S-VHS recording mode will be
automatically selected.
9
Press STOP to stop recording.
Note
If VHS cassette is loaded, the VHS recording mode will be automatically
selected regardless of the "S-VHS REC" setting.
POWER
SLP
VCR
CH
POWER
SLP
VCR
POWER
SLP
VCR
CH
"ON"
is selected.
REC TIMER
POWER
SLP
VCR
REC
CH