Changing The Hydraulic Clutch Fluid - KTM 500 EXC Owner's Manual
Hide thumbs
Also See for 500 EXC:
- Owner's manual (119 pages) ,
- Setup instructions (31 pages) ,
- Owner's manual (136 pages)
Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.45
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
M00208-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
M00217-10
–
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
M00209-10
.
with membrane
.
with the appropriate hydraulic fluid.
p. 113)
.
and mount bleeding
of the master
4 mm (0.16 in)
68
Hide quick links:
Advertisement
Table of Contents
