12
SERVICE WORK ON THE CHASSIS
12.19
Installing the shock absorber
12.20
Removing the seat
12.21
Mounting the seat
Main work
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
M00215-10
Main work
–
Push splash protector
tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
M00215-11
Screw, bottom shock
absorber
Info
The heim joint for the shock absorber at the swingarm is Teflon coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101346-10
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
M00176-10
and lower the rear wheel with the swingarm as far as possible
, push splash protector
to the side and position the shock absorber. Mount and
.
M12
.
M12
.
to the side, and remove the shock
80 Nm
Loctite
(59 lbf ft)
80 Nm
Loctite
(59 lbf ft)
p. 48)
M6
10 Nm (7.4 lbf ft)
56
®
2701™
®
2701™