Conversion Lens - Panasonic HDC-SDT750 Operating Instructions Manual

3
Tighten the attachment screw of the
3D Conversion Lens by rotating to
LOCK.
≥ Be careful not to overtighten. If the 3D
Conversion Lens is overtightened, it may not be
possible to remove it from the unit.
≥ Attach the 3D Conversion Lens securely so it will
not tilt or move.
∫ Recording 3D video
When using for the first time, be sure to adjust the 3D Conversion Lens attachment position.
≥ Turn off the unit.
≥ Change the mode to
1
Attach the 3D Conversion Lens to the unit. (l 52)
2
Turn on the unit.
≥ Turn on with the unit in a horizontal state.
≥ The 3D Conversion Lens adjustment mode screen will appear automatically after
performing the initial setting.
≥ If the 3D Conversion Lens adjustment mode screen does not appear automatically,
set from the menu.
([SETUP] # [3D CONV. LENS SETUP])
≥ If the unit is turned on with the USB cable still connected, the USB connection will take
priority.
3
Attach the lens front cap to the 3D

Conversion Lens.

≥ 2 screens will appear.
≥ The horizontal line for adjustment on the lens
front cap is displayed on the screen.
A Guide Line
4
Touch [ADJUST].
≥ If the black vertical line and the black horizontal line are within the red guidelines A and
adjustment is not required, touch [EXIT] and proceed to step 11.
≥ Perform the adjustment in a bright location where the horizontal line for adjustment will be
clearly visible.
≥ The 3D Conversion Lens cannot be adjusted using the viewfinder.
.
LOCK LOCK

53
VQT3B52