Avoiding Fuel-Related Problems - Honda HRS216PKUA Owner's Manual

Table of Contents

Advertisement

When properly maintained, your Honda powered product should provide years of trouble-free operation. This includes the fuel system.
However, petrol can quickly deteriorate (in as little as 30 days) causing starting or running problems and, in some cases, damage to the fuel
system. Most fuel-related problems can be avoided by following the precautions listed below. Fuel system damage and engine performance
problems resulting from deteriorated petrol are not covered by the Limited Warranty (see
Follow These Precautions to Prevent Most Fuel-Related Problems
During the Normal Mowing Season
Do not use petrol containing more than 10% ethanol (E10). Not all
automotive fuel is safe to use in your power product.
Store fuel in a clean, plastic, sealed container approved for fuel
storage.
Store your fuel supply container away from direct sunlight; if the
container has a vent, keep it closed.
Purchase only enough fuel to last for 1 to 2 months (about 30 to 60
days).
If you purchase enough fuel to last for more than 60 days, add a fuel
stabilizer to your storage container when you fill it.
Keep your product's fuel tank full of fresh fuel when not in use. Turn
the fuel valve OFF.
Keep the air filter clean and properly serviced. Check it before each
use.
3 to 4 Weeks Before Next Use
Keep your product's fuel tank full of fresh fuel when not in use. Turn
the fuel valve OFF.
Turn the fuel valve to the OFF position, start the engine and let it run
approximately 3 minutes until the carburetor is empty and the
engine stops.
1 to 3 Months Before Next Use
If you did not add fuel stabilizer to your fuel storage container when
you filled it up, fill your product's fuel tank with fresh fuel.
Add fuel stabilizer to the product's fuel tank according to the
stabilizer manufacturer's instructions.
Run the engine outdoors for 10 minutes.
Turn the fuel valve to the OFF position, start the engine, and let it
run approximately 3 minutes until the carburetor is empty and the
engine stops.
More Than 3 Months Before Next Use
Start the engine and let it run long enough to empty all the fuel from
the entire fuel system, including the fuel tank.
Do not allow fuel to remain in your product's fuel tank for more than
3 months (about 90 days) of inactivity.
16

AVOIDING FUEL-RELATED PROBLEMS

page
22).
Higher levels of ethanol in fuel attract water, and can corrode or
damage the fuel system and cause performance problems.
A plastic container eliminates the risk of rust and metallic
contaminants from a metal container entering the fuel system.
fuel will deteriorate faster when exposed to air and sunlight.
Fuel deteriorates with age so try to avoid storing it for long periods,
especially in summer heat.
Fuel stabilizer will extend the shelf life of fuel, but it will not
reconstitute stale fuel.
If the fuel tank is only partially filled, air in the tank will promote fuel
deterioration.
A properly maintained air filter will help prevent dirt from entering the
carburetor. The small passages inside the carburetor can become
blocked.
If the fuel tank is only partially filled, air in the tank will promote fuel
deterioration.
The small amount of fuel in your engine's carburetor will deteriorate
faster than the fuel in the fuel tank due to its small volume and heat
from the engine.
If the fuel tank is only partially filled, air in the tank will promote fuel
deterioration.
Fuel stabilizer will extend the life of fuel, but it will not reconstitute
stale fuel.
This makes sure treated fuel has replaced untreated fuel throughout
the fuel system.
The small amount of fuel in your engine's carburetor will deteriorate
faster than the fuel in the fuel tank due to its small volume and heat
from the engine.
All fuel stabilizers have a shelf life. It is good practice to empty the
fuel system for long term inactivity.
Reason
Reason
Reason
Reason

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents