Samsung DW60J9960 Series User Manual page 13

Sanitize
7
Dry+ (Child Lock)
8
Display
9
User Manual_DW9000H-Series-00159E-01_EN.indd 13 User Manual_DW9000H-Series-00159E-01_EN.indd 13
With the Sanitize option selected, the water temperature is increased to 70 ˚C
for high temperature sanitization.
You cannot select the Sanitize option if you select the Delicate cycle.
Use this option when you want to dry your dishes more completely.
The temperature rises to 65 ˚C in the fi nal rinse cycle and dry time is increased.
If you select the this option, electricity consumption is increased.
*Child Lock : This option allows you to lock the buttons on the control panel -
except the Power button - so children cannot accidently start the dishwasher
by pressing the buttons on the panel. Only the Power button remains active.
To lock or unlock the buttons on the control panel, press and hold the Dry+
(Child Lock) button for three (3) seconds.
• When the Power is On : Press and hold the "Dry+ (Child Lock)" button for
three (3) seconds.
• When the Power is Off : Push the Power button fi rst, and then press and
hold the "Dry+ (Child Lock)" button for three (3) seconds.
• Child Lock remains active until you turn it off . You cannot select cycles or
options or start the dishwasher when Child Lock is on.
Displays cycle time and remaining hours and minutes, Delay Start hours, and
check messages.
If an problem occurs during an operation, an check message is displayed with
a warning sound.
Refer to the "Troubleshooting and information codes" section on page 32.
Child Lock indicator
- Turns on if the Child Lock is set (or the dishwasher is in the standby or
pause modes).
- Turns off while the dishwasher is operating.
- When Child Lock is on, the Child Lock indicator blinks for several
seconds if any button except the Power button is pressed.
Self Clean indicator
- Turns on when the Self Clean option is enabled (or the dishwasher is
in the standby or pause modes), but turns off while the dishwasher is
operating.
- Blinks for 5 seconds every 20 to 22 cycles.
- The cycle counter disappears when the Self Clean operation is complete
or when the dishwasher reaches the 23rd cycle without the Self Clean
cycle being used. (The Reset or Self Clean operation is not counted by
the cycle counter.)
Rinse Refi ll indicator
- Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in
the standby or pause modes).
- Turns off while the dishwasher is operating.
Lack of salt indicator (*applicable models only)
- Turns on when the water softener runs out of salt. (or the dishwasher is
in the standby or pause modes.)
- Turns off while the dishwasher is operating.
English - 13
2015-03-24 2015-03-24 5:25:54 5:25:54