Step 5. Plug In And Place; Step 6. Level The Range - Samsung NX58J7750S series Installation Manual

Step 5. Plug in and place

WARNING
BEFORE OPERATING OR TESTING, follow
the grounding requirements on pages 20 ~
22 in this manual. Improper connection of
the grounding plug can result in a risk of
electric shock.
Gas Range Plug

Step 6. Level the range

Leveling leg
NOTE
Adjusting the two front legs is usually
sufficient, but all four legs adjust if
necessary.
Install_NX58J7750S _AA,AC_DG68-00624A-03_EN.indd 29
• All gas ranges come with a power cord.
The power cord is connected to the rear
of the range. Please review "Electrical
requirements" on pages 20 ~ 22.
• All U.S. and Canadian models are produced
with a 3-wire, 120-volt, 60-Hertz electrical
system. The entire system, including the
power cord, is preinstalled and prewired
1. Plug in the power cord. Make sure the
outlet meets local or national electrical
codes as referenced on pages 20 ~ 22.
2. Slide the range into place.
3. Check the gas supply line to make sure
it did not get damaged and it stayed
connected during positioning.
4. Check to make sure the back leg of the
range has slid into the anti-tip bracket.
Carefully tip the range forward to ensure
that the anti-tip bracket engages the back
brace and prevents tip-over.
1. Make sure the range is positioned where
you want it.
2. Using a wrench, level the range by
turning the front leveling legs in or out
as necessary. Counterclockwise shortens
the leg and lowers the range. Clockwise
lengthens the leg and raises the range.
NOTE
Adjust the leveling legs only as far as
necessary to level the range. Extending
the leveling legs more than necessary or
removing legs can cause the range to be
unstable.
English 29
2015-08-07 10:24:51