Maintenance - Cub Cadet 3208 Operator's Manual

From just above the right axle carrier,
inside the right frame rail, slowly turn
the hex nylon lock nut at the end of
the brake rod as follows to adjust the
brake (Refer to Figure 16):
• Turn the nylon lock nut clockwise to
increase the braking force.
• Turn the nylon lock
counterclockwise to decrease the
braking force.
Recheck the brake adjustment to
ensure proper operation, and readjust
as necessary. If brake
does not correct the problem, see your
authorized Cub Cadet dealer.
SECTION 9: MAINTENANCE
Operation to
be performed
Grease front wheel bearings
Grease L/R steering knuckles
Grease front pivot axle
Check engine oil level
Change engine oil and filter
Check transmission oil level
Change transmission oil filter
Change transmission oil
Check air cleaner & housing
Clean & re-oil foam air
pre-cleaner
Change air cleaner
paper cartride
Change Coolant
‡ Change oil and filter after first 8 hours
† More often under dusty conditions
†† Clean every 25 hours or more often under dusty or dirty conditions
NOTE: We do not recommend the use of a pressure washer or garden hose to
clean your unit. They may cause damage to electrical components; spindles;
pulleys; bearings; or the engine. The use of water will result in shortened life and
reduce serviceability.
While guiding the transmission release
rod through keyhole and the oil fill
tube/dipstick into the transmission,
position the rear drawbar on the
frame. Secure with the four hex tapp
screws.
Turning Radius Adjustment
nut rod
This tractor is equipped with hydraulic
power steering which is set at the
factory. The turning radius should be
equal for both left and right hand
turns. If adjustment is necessary
adjustment
please contact your authorized Cub
Cadet dealer.
Maintenance Chart
•
•
•
•
‡
•
•
††
†
Every 400 hrs.-Contact your Cub Cadet dealer
17
• • •
• • • • •
• •
† †