Table of Contents
Advertisement
ASSEMBLY 組裝說明
The detailed assembly steps are shown from page 26 to 29.
詳細組裝圖請參考第26~29頁。
Assemble in right order
依標示順序組裝
Tail Pulley
Tail
尾惰輪
機尾
Belt
皮帶
Rotate the belt 90°
counterclockwise.
反時針方向旋轉皮帶90°
DEVICE CONNECTION 設備連接說明
The wire connection between devices and receiver may differ in different brand
of radio system. The figures below are for your reference, please read your
radio system manual to find the proper connections.
各品牌遙控系統的電子設備與接收機間接線方法或有差異，以下圖示為安裝範例，實際接
線方式請參閱您的遙控器說明書。
JR / SPECTRUM
Pitch
Aileron
螺距
左右/副翼
Battery of
receiver
4.8-5.8V
接收器電池
7 channel receiver
4.8-5.8V
七動作接收器
BELT INSTALLATION
2
傳動皮帶安裝
Guide Pulley
主惰輪
Autorotation Tail
Drive Pulley
尾驅動輪
Nose
機首
3
Throttle
Elevator
油門
前後/升降舵
Governor
定速器
Gyro
陀螺儀
Servo Cable 連接線
Gain Wire 訊號線
1
(1) Insert the tail boom into the boom bracket and push it all the way to
the end.
將尾管穿入尾管固定座內並推到底。
(2) Warp the belt onto the autorotation tail drive pulley; note the belt
direction of rotation when warping.
將皮帶繞過尾驅動輪；注意安裝時皮帶的扭轉方向。
(3) Gently pull back the tail boom until the tension of the belt allows no
more than 5 mm (3/16") of free play in the belt.
慢慢地將尾管向後拉緊，直至按壓皮帶時，間隙小於5 mm (3/16") 為最佳。
(4) Move the tail boom supports bracket and metal clip to their proper
positions, and then tighten the screws to avoid unexpected
invagination of tail boom.
將尾管支撐架及止擋環定位，並鎖緊螺絲，以防止尾管內鏥。
(5) Secure all other screws tightly and mount the blades.
鎖固所有的其他螺絲並安裝上旋翼。
ACE RC / FUTABA / HITEC
Rudder
Pitch
尾舵
螺距
Battery of
receiver
4.8-5.8V
接收器電池
4.8-5.8V
-5-
Aileron
副翼
Elevator
前後/升降舵
Pitch
Rudder
螺距
尾舵
Throttle
油門
Aileron
Throttle
左右/副翼
油門
Governor
定速器
7 channel receiver
七動作接收器
Elevator
Rudder
前後/升降舵
尾舵
Gyro
陀螺儀
Servo Cable 連接線
Gain Wire 訊號線
Advertisement
Table of Contents
