Operational - Fujitsu Fi-7030 Operator's Manual

Appendix
Item
Grayscale level
Interface
*1: Long page scanning supports documents with a length of up to 5,588 mm (220 in.) when the resolution is set to 200 dpi or less.
*2: When scanning plastic cards from the ADF, load one card at a time in the ADF paper chute (feeder). When you scan an embossed card, it is
recommended that the card should be loaded face-down in the ADF paper chute horizontally.
*3: Note that this is the hardware limitation, and the software's processing time such as data transfer time is added to the actual time of scanning.
*4: The capacity varies depending on the paper weight.
For details, refer to "2.2 Documents for Scanning" (page
*5: Use the USB cable that is supplied.
When connecting the USB cable to a USB hub, make sure you connect it to a USB hub that is connected to the USB port of a computer.
Connection with USB 2.0 requires the USB port and the hub to support USB 2.0. Also note that the scanning speed slows down when USB 1.1 is used.
Specification
256 gradation levels
USB 2.0/1.1 (*5)
35).
Notes
1024 gradation levels (10-bit)
during internal processing
B Type
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
145