Table of Contents
Advertisement
Motion Detect Zones:
00
6. SYSTEM SET(I) -
KEY BUZZER
:
LOSS BUZZER
:
QUAD LINE
:
BLANK COLOR
:
SLAVE OUT
:
TITLE/TIME
:
PAN/TILT
PAN/TILT Enables/Disables Pan Tilt support on Channel 1.
:
ALARM OUT
:
DEFAULT SET
:
7. SYSTEM SET(II)
HDD INFO DISP :
RS-232 BAUD
:
RATE
PASSWORD
:
PASSWORD
:
SET
8. HDD/REC SET
REC QUALITY
[BEST]
:
01
03
When enabled, a tone will sound for each key press on the unit.
[Y]
[Y]
When enabled, a tone will sound when video signal is lost.
[Y]
This option activates/deactivates the border-line separation in
Quad Mode.
[BLUE]
This allows you to toggle the blank screen color from Blue, Gray or
Black
[QUAD] This selects whether the Slave output will be QUAD always, or
ACTUAL, which outputs what is shown on the display.
[TL/TR] This allows you to change the OSD position for the camera Titles
and Time. The default setting is Top Left for Tile and Top Right for
Time.
N/O
This selects whether the Alarm Output will be a Normally Open or
Normally Closed activation.
[N]
Selecting Yes for this option sets all program settings including
Time/Date back to their factory defaults.
[BYTE] This option selects whether the OSD Hard Drive information will
be shown as [BYTE} for number of remaining bytes or [PERCENT]
for the percent of the drive remaining.
[OFF] This sets the RS-232 baud rate if connecting to a PC for control of
the DVR. Selectable baud rates are [2400], [4800], [9600] and
[19200]
[N]
This option determines whether a password will be required to
enter the setup menu.
[0000] If password protection is desired, enter the password in this
section. Press Enter when complete.
Select the quality setting to be used for recording – [LOW],
[NORMAL], [HIGH], or [BEST]
02
05
04
Advertisement
Table of Contents
