Checking The Quicksilver Mercathode System - MerCruiser 350 MAG Owner's Manual

Section 5 - Maintenance
Bearing carrier anode (Bravo One)
Propshaft anode (Bravo Three)

Checking the Quicksilver MerCathode System

The MerCathode system should be tested to ensure adequate output. Perform the test
where boat is moored, using the reference electrode and test meter. Contact your
authorized Mercury MerCruiser dealer for service and information .
Page 90
Description
Gearcase anode plate
Ventilation plate anode
MerCathode System
Anode kit (if equipped)
Trim cylinder anodes
Location
Mounted on the underside of the lower
gearcase.
Mounted on the front of the gearcase.
The MerCathode electrode is mounted
to the underside of the gimbal housing.
The MerCathode controler is mounted
on the engine or on the boat transom.
The controler harness connects to the
electrode harness.
Mounted to the boat transom.
Mounted on each of the trim cylinders.
Located in front of the propeller,
between the front side of the propeller
and the gear housing.
Located behind the aft propeller.
90-864195072 OCTOBER 2007
Figure
20336
20338
20340
20341
20342
20343
20344