Slim Binnacle Console Mount Features - Single Engine - MerCruiser 350 MAG Owner's Manual

Slim Binnacle Console Mount Features ‑ Single Engine
a
Control Handle - Operation of the shift and throttle are controlled by the movement of the
control handle. Push the control handle forward from neutral with a quick, firm motion to
the first detent for forward gear. Continue pushing forward to increase speed. Pull the
control handle back from neutral with a quick, firm motion to the first detent for reverse gear
and continue pushing back to increase speed.
Trim/Tilt Switch (if equipped) - Refer to Power Trim.
Active Light - The active light is illuminated to show the remote control is active and ready
for use.
Neutral Light - The neutral light is illuminated when the engine is in neutral gear position.
NOTE: Gear position is determined by sensing the position of the shift actuator on the
engine, not the position of the gear switch.
Stop/Start Button - Allows the boat operator to start or stop the engine without using the
ignition key.
Throttle Only/Station Select Key - Allows engine throttle advancement without shifting
the engine. The throttle only/station select button also allows the boat operator to select
which remote control is in control of the engine operation when operating with multiple
helms. Refer to Dual Helm Station Transfer.
Detent Tension Adjustment Screw - This screw can be adjusted to increase or decrease
the effort required to move the control handle out of the detent positions (cover must be
removed). Turning the screw clockwise will increase tension.
Control Handle Friction Adjustment Screw - This screw can be adjusted to increase or
decrease the tension on the control handle (cover must be removed). This will help prevent
unwanted motion of the handle in rough water. Turn the screw clockwise to increase
tension and counterclockwise to decrease tension.
90-864195072 OCTOBER 2007
b
START
STOP
c
a - Control handle
b - Trim/tilt switch
c - Active light
d - Neutral light
e - Start/stop button
f - Throttle only/station select key
g - Detent tension adjustment
h - Control handle friction adjustment screw
Section 2 - Getting to Know Your Power Package
d
e
g
f
+
h
14637
Page 23