Samsung SNC-B5395 User Manual page 76

To set the motion detection function
1
Click <EVENT>  <MOTION>.
The MOTION window appears.
2
To complete the setting,
click the [Apply] button.
The settings are saved.
<M.D. Function>: <Enable> activates the motion detection function, while <Disable> disables the
<M.D. Configuration>: You can set motion detection performance parameters.
- <Motion Sensitivity>: Select a motion detection function sensitivity from <High>, <Medium> and
- <Motion Area>: You can set an area to detect motion.
<Activation Time>: You can set time to accept a motion detection to take an action.
- <Always>: Always conducts the <Action> setting when a motion is detected.
- <Only Scheduled Time>: Conducts the <Action> setting for a motion detection only when it occurs
<Action>: You can set an operation to be conducted when a motion is detected.
- <Alarm Output>: Determines a motion detection output port to which the alarm signal is to be sent.
- <Output Duration>: Determines the period of time to output the alarm signal to the specified alarm output
- <Alarm Image Transfer>: If <On> is selected, a JPG image is transmitted through FTP or Email (SMTP) or
72_
Setting Up
function.
<Low>. The <High> option provides high sensitivity of motion detection and
generates motion detection event if a small motion is detected.
during the specified time period on the specified day of the week. The Start
Time must prior to and must differ from the End Time.
port when a motion is detected. If another detection event is generated during the alarm
output, the delay time is recalculated on the basis of the most recently generated motion
detection.
saved on the SDHC memory card according to the <EVENT>  <TRANSFER
SETUP> settings.