Qls 2000 Series Operation & Setup Manual page 8

QLS 2000/3000 Series Digital Color Printers
Pin table for the serial interface is:
1 ........................................not used
2 ........................................TXD (transmit data)
3 ........................................RXD (receive data)
4 ........................................DTR (data terminal ready)
5 ........................................ground
6 ........................................DSR (data set ready)
7 ........................................internally connected
8 ........................................internally connected
9 ........................................not used
Media Travel Sensors ....................
Transmissive .....................Senses the gap, inverted gap, notch,
Reflective ..........................Senses a black mark on the underside of
TTR Media Roll Length ................300 meters
TTR Media Widths........................1.75, 2, 2.75, 3.25, 3.75 inches
Label Media...................................die cut or continuous; paper, plastic, or synthetics;
Min/Max Label Media Size ...........1" to 4.625" W x 0.2" to 22" L
Max Label Thickness.....................12 pt
Min/Max Print Width ....................5 mm to 4.4 inches
2
string hole, or punch out. This sensor is
marked by a sliding red handle and
pointer that is to be positioned over the
gap, notch, string hold, or punch out.
a label or tag. This is a fixed sensor and
is not adjustable.
card or care tag
Before You Get Started