Table of Contents
Advertisement
QLS 2000/3000 Series Digital Color Printers
TO LOAD TTR:
1.
Be sure power is Off. Raise the printer cover.
2.
Fully seat TTR roll on the TTR unwind mandrel. Ensure that the ribbon
unwinds to the left of and beneath the roll.
3.
Fully seat a cardboard take-up core on the associated TTR rewind mandrel.
4.
Open the printhead (flip printhead cam lever counterclockwise on standard
printstations, clockwise on inverted printstations).
5.
Advance the TTR around the outside of each station's TTR guide roller(s).
6.
Advance the TTR between the printhead and the platen roller.
7.
On standard printstations, advance the TTR over the TTR guide spindle.
On inverted printstations, advance the TTR around the outside of the
station's two guide spindles.
8.
On standard printstations, advance the TTR beneath and around the
cardboard take-up core on the rewind mandrel. On inverted printstations,
advance the TTR above and around the take-up core.
9.
Tape the TTR to the core.
10. Close the printhead.
11. Repeat procedure for remaining printstations.
Adjustment of the ribbon tension may be required after loading TTR. If the
TTR is wrinkling or smudging, adjust the tension to alleviate these conditions.
12
Printer Setup
Advertisement
Table of Contents
