Table of Contents
Advertisement
TROUBLESHOOTING
Faults
The engine does not turn when the
starter button is pressed
Engine turns only if the clutch lever is
drawn
Engine turns although a gear is
engaged
Engine turns but does not start
Possible cause
Operating error
Battery discharged
IGNITION, FUEL PUMP, or POWER RELAY
fuse blown
Main fuse burned out
Ignition/steering lock or emergency
OFF switch defective
Defect in safety start system
Immobilizer control unit not activated
Malfunction in CAN bus communica-
tion
Combination instrument defective
Control unit for electric start lock
defective
The vehicle is in gear
Defect in safety start system
Defect in safety start system
Coupling of fuel hose connection not
connected
Socket connector of wiring harness
oxidized
Defect in fuel injection system
Action
–
Carry out the start procedure. (
–
Recharge the battery.
x
–
Check the closed current.
–
Change the fuses in the fuse box. (
–
Change the main fuse. (
–
Check the emergency OFF switch.
–
Check the ignition/steering lock.
–
Check the safety start system.
–
Activate the immobilizer control unit.
–
Check the CAN bus communication.
–
Check the combination instrument.
–
Check the control unit of the electric start
lock.
x
–
Shift the transmission to neutral.
–
Check the safety start system.
–
Check the safety start system.
–
Reconnect coupling of fuel hose connection.
–
Clean the socket connector and treat it with con-
tact spray.
–
Read out the fault memory using the KTM diag-
nostics tool.
x
174
p. 49)
(
p. 114)
x
p. 121)
p. 118)
x
x
x
x
x
x
x
x
Advertisement
Table of Contents
