Troubleshooting Tips - GE PCR06BATSS Owner's Manual And Installation Instructions

Before you call for service...

Troubleshooting Tips

Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Appliance does not
operate
Vibration or rattling
(slight vibration
is normal)
Motor operates for
long periods or cycles
on and off frequently
Compartment
too warm
Appliance has odor
Door not closing
properly
14
Possible Causes
Appliance may be in defrost
cycle.
Appliance is unplugged.
The circuit breaker is tripped/
the fuse is blown.
GFI outlet is tripped.
Appliance is on an
uneven surface.
Normal when appliance
is first plugged in.
Often occurs when large
amounts of wine or beverages
are placed in the appliance.
Door left open.
Hot weather or frequent
door openings.
Temperature control set
at the coldest setting.
Normal when appliance
is first plugged in.
Often occurs when large
amounts of wine or beverages
are placed in the appliance.
Temperature control
not set cold enough.
Warm weather or frequent
door openings.
Door left open.
Interior needs cleaning.
Door gasket is sticking or
folding over.
The door is hitting an internal
component inside the appliance.
What To Do
• This is normal. Compressor does not operate for about
30 minutes when in defrost cycle.
• Push the plug completely into the outlet.
• Replace fuse or reset the breaker.
• Reset outlet.
• GFI outlet is not recommended.
• Adjust the leveling legs as shown in the Installation
Instructions.
• Wait 24 hours for the appliance to completely
cool down.
• This is normal.
• Always make sure that the door is closed after opening.
• Check to see if a bottle is holding door open.
• This is normal.
• Allow 24 hours for temperature to change.
• Wait 24 hours for the appliance to completely
cool down.
• This is normal.
• See Temperature Control section.
• See Temperature Control section.
• Always make sure that the door is closed after opening.
• Check to see if a bottle is holding door open.
• See Care and cleaning.
• Keep open box of baking soda in appliance; replace
every 3 months.
• Apply petroleum jelly or paraffin wax to the face
of the gasket.
• Adjust internal components to prevent interference.