Advertisement
4
Fill the bottom of the U groove (located on the periphery of the section) with a continuous bead of DOW CORNING silicon, diameter
approximately Ø 5 mm.
silicon must not be applied 100 to either side of the connection (nipple assembly area).
Dimensions are given in millimeters.
5
Fit the Ø 10.5 mm diameter thermocord into this U groove and into the groove which circles the furnace.
Note: Do not pull on the seal while inserting it. Otherwise, you may stretch it and reduce its thickness.
10
NXR5i
25/09/2012 - 300029104-001-02
Advertisement
