PHW RANGE HOOD SERIES INSTALLATION Recirculating Kit # AVPH1 INSTRUCTIONS DANGER: Electric shock and explosion hazard! Before installation, turn off power at the circuit breaker or fuse box. Parts Included Top cap (Qty 1) Charcoal Filters (Qty 2) Tools and Materials Required The following items are not provided with the kit and are required for proper installation: •...
Page 2
PHW Series Hood Recirculation Kit Instructions STEP 1 Make sure power to the circuit that supplies power to the hood is turned off. STEP 2 Install the chimney mounting bracket and the blower assembly according to the installation instructions included with the hood. STEP 3 Wire the hood according to the hood installation instructions.
Page 3
PHW Series Hood Recirculation Kit STEP 7 Using sheet metal screws and duct tape, attach the end of the duct length Chimney mounting cut in step 6 to the exhaust outlet on bracket the top of the blower assembly. Use a Top cap level to make sure the duct is vertical.
Page 4
STEP 11 Remove the protective plastic from the charcoal filters included with the kit. STEP 12 Insert the charcoal filters into both openings the mesh filters where removed from in step 10. The hood is designed to allow for both the charcoal filters and the mesh filters to fit inside the hood at the same time. When you insert the charcoal filter, make sure the removal tab is toward the bottom. See diagram below. STEP 13 Reinstall the mesh filters. Charcoal filter shown installed Removal Under side of hood Reinstall mesh type filter with charcoal filter underneath Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com...