Master Lock MLD08E Instructions For Use Manual page 6

Bolting Down Your Safe
Bolt down kit contents:
2 Lag screws
2 Washers
Tools needed to bolt safe to a surface:
Drill
Wrench
1
WARNING
DO NOT DRILL FROM ANY LOCATION INSIDE THE SAFE.
NOTE: This product is intended to be mounted with a horizontal orientation.
2
3
Drill the holes in the surface using the appropriate diameter and depth for the type of
hardware and the mounting surface being used.
4
Replace the safe over the newly created holes.
A
Install the screws and washers as required.
B
WARNING
MASTER LOCK IS NOT RESPONSIBLE FOR COSTS INCURRED IF THE UNIT IS TO BE
REPLACED.
BOLTING/UNBOLTING THE UNIT IS AT A CONSUMER'S EXPENSE AND DISCRETION
Select a suitable location for your safe. Set the safe in place, and use
the pre-drilled holes provided on the bottom of the safe to mark the
location of the holes to be drilled in the surface.
Move the safe while you drill the marked holes in the surface.
6