Belkin N1 User Manual page 86

Troubleshooting
The Setup Assistant completed installation, but my web
•
browser doesn't work.
I am unable to connect to the Internet. The "modem" LED on
•
my Router is on, and the "internet" LED is blinking.
1.
If you cannot connect to the Internet, the "modem" LED is on,
and the "internet" LED is blinking, the problem may be that your
connection type may not match the ISP's connection.
2.
If you have a "static IP address" connection, your ISP must
assign you the IP address, subnet mask, and gateway address.
Please refer to the section entitled "Alternate Setup Method" for
details on changing this setting.
3.
If you have a "PPPoE" connection, your ISP will assign you a
user name and password and sometimes a service name. Make
sure the Router's connection type is configured to PPPoE and the
settings are entered properly. Please refer to the section entitled
"Alternate Setup Method" for details on changing this setting.
4.
You may need to configure your Router to meet the specific
requirements of your ISP. To search our knowledge base for
ISP-specific issues, go to: http://web.belkin.com/support and
type in "ISP".
If you are still unable to access the Internet after verifying these
settings, please contact Belkin Technical Support.
84 84
1
2
3
4
5
6
7
8
9
10