Belkin N1 User Manual page 78

Manually Configuring Network Settings
4.
Select the "TCP/IP" tab
see "Manually" or "Using DHCP". If you do not, check the
(5)
PPPoE tab
selected. If it is, you will need to configure your Router for a
PPPoE connection type using your user name and password.
5.
If "Manually" is selected, your Router will need to be set up
for a static IP connection type. Write the address information
in the table below. You will need to enter this information into
the Router.
6.
If not already selected, select "Using DHCP" next to "Configure"
(4)
, then click "Apply Now".
Your network settings are now configured for use with the Router.
(3)
. Next to "Configure"
to make sure that "Connect using PPPoE" is NOT
(4)
76 76
, you should
1
2
3
4
5
6
7
8
9
10