3DR X8+ Operation Manual page 7

2 Unfold Legs
Remove the bolts and nuts to the inside of the folded legs (1),
unfold the legs, re-insert the bolts, and secure with the nuts (2).
1
2
3 Attach Propellers
The X8 uses SF and SFP propellers. Labels are found on the individual
propeller packages and on the propellers themselves. The diagram
below shows which motors require SF or SFP propellers. Accurate
assembly of SF and SFP propellers is critical for the X8 to fly correctly.
To attach each propeller, remove the nut and washer from the motor,
and add the correct type of propeller with the writing on the propeller facing
the sky. (This is a tight fit; apply pressure and twist the propeller onto the
motor.) Replace the washer over the propeller, and use the propeller
wrench to tighten the nut on top.
bottom motor:
X8 Assembly: Unfold Legs
top motor: SFP
bottom motor: SF
top motor: SF
SFP
X8 Propeller Order
X8 Propeller Assembly
top motor: SF
bottom motor: SFP
top motor: SFP
bottom motor: SF
!
Ensure that the writing on all
propellers faces the sky.
5