Samsung HT-F6550W User Manual page 16

Connections
| CAUTION |
\
If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall wherever you
want to hang a speaker, and then, using the hole in the rear of each speaker, carefully hang each speaker on a screw
or nail.
\
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
\
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
\
Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien
substances into the duct (hole) of the subwoofer speaker.
\
Do not hang the subwoofer on the wall using the duct (hole).
\
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.
\
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of
any obstructions.
\
If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II.
\
In 2-CH mode, you will hear no sound from the wireless surround speakers.
| NOTES |
\
If you place a speaker near your TV set, the screen color may be distorted because of the magnetic field.
\
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to
the product, sound from the speakers may be disrupted because of interference.
\
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment or any other device that uses
the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference.
\
The maximum transmission distance from the product to the wireless receiver module is about 10 meters, but may
vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and
the wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.
\
If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless
receiver module. With the product turned off, press "0""1""3""5" on the remote control. Turn on the wireless
receiver module. Then, press and hold the "ID SET" button on the back of the wireless receiver module for 5
seconds, and then turn the product on.
16
|
English