Error Messages - Velleman CTC1000 User Manual

interference

14.3 Error messages

The error message is displayed in short form as below:
Message displayed
AC failure
GSM Signal
Interference
Panel L.B.
Panel Tamper
(Sensor w/ Zone Name) + L.B.
(Sensor w/ Zone Name) + out
(Sensor w/ Zone Name) + Tamper
Sim Card?
Example: the message DC Z 01 L.B. means Zone 1 Door Contact is low battery.
Note
While you arm the system, if any of door contact or PIR is triggered, arming is also prohibited and the sensor
triggered will be displayed as error message.
Message displayed
(DC w/ Zone Name) + open
(IR w/ Zone Name) + Active
15. Remote commanding via SMS message
The unit can be controlled by remote control commands sent via sms messages.
Remember to change the Language setting of your mobile phone to English before proceeding.
SMS Remote Control Command Table
Control Command
00
10
11
20
21
30
31
For 2-digit Remote Control Command
Send the SMS message to command the Unit to enter Arm Mode and send a confirmation SMS back to your
mobile phone. The format is:
MICHAEL 2222 11 00
MICHAEL SMS keyword
V. 04 – 11/02/2016
CTC1000
the panel will light while this error message can be viewed on
LCD under Fault Display. No alarm event will be reported.
When the system is programmed with Interference detection ON
•
and when there is an interference detected for 30 seconds, the
yellow LED will light up. The error message can be viewed on
LCD under Fault Display in the user menu.
Meaning
AC Power Fail
GSM out of signal
interference detected
low battery on the control panel
sabotage on the control panel
low battery on the sensor
sensor out-of-order
sabotage on a sensor
SIM card missing
Meaning
Door Contact triggered
PIR triggered
Action
hang up with Confirmation
disarm
arm
UR#1 deactivated
UR#1 activated
UR#2 deactivated
UR#2 activated
35 ©Velleman nv