Duress Code - Velleman CTC1000 User Manual

2. Press OK again.
7.6

Duress Code

Use Can be used to arm or disarm the alarm system.
•
Entering the code when under duress from an assailant triggers a silent alarm and
•
sends a secret message to the programmed mobile phones.
No siren will sound for duress alarm.
•
Default value Not set
•
Properties 4 digits
•
Optional
•
Will be cleared when resetting the system (see chapter System reset)
•
To set a duress code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Duress Code and press OK.
2. Key in a 4 digit code and press OK.
3. Repeat the code and press OK.
To change a duress code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Duress Code and press OK.
2. Press
.
3. Key in a 4 digit code and press OK.
4. Repeat the code and press OK.
To delete a duress code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Duress Code and press OK.
2. Press OK again.
7.7 Master Code
Use
• Required together with the pin code to enter the device's Program mode.
Default value 1111
•
Properties 4 digits
•
Mandatory
•
Cannot be deleted
•
Will be reset to default when resetting the system (see chapter System reset)
•
The master code needs to be different from the pin codes
•
V. 04 – 11/02/2016
CTC1000
11 ©Velleman nv