Enabling Write-Protection - FOR-A MBP-100PD Series Operation Manual

4. Enter a new IP address, Subnet mask and other necessary setting values that suit your
network, and then click OK.
5. It returns to the dialog box that appeared in step 3. Click OK.
Other drivers can be installed in the same manner.

4-5. Enabling Write-Protection

Write-protection must be enabled after the setting or the installation is finished. The
procedure is as follows.
1. Double-click ewf_enable.bat in D:\forawork to execute the batch file.
2. Command Prompt opens. Press any key on the keyboard.
3. Check that Boot Command is set to Enable, and then press any key on the keyboard once.
Windows automatically restarts. (See section 4-2. "Disabling Write-Protection".)
After the restart the write-protection on the C drive is enabled.
23