Cleaning Tips - Kärcher K360M Operator's Manual

CLEANING TIPS

Deck Cleaning
(with or without detergent)
Pre-rinse deck and surrounding area with
fresh water. Place detergent suction tube
directly into cleaning solution and apply to
surface at low pressure. For best results,
limit your work area to smaller sections of
approximately 25 square feet. Allow
detergent to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure in a long sweeping
motion keeping the spray nozzle
approximately 3-6 inches from the cleaning
surface. Always clean from top to bottom
and from left to right. When moving on to
a new section of the cleaning surface, be
sure to overlap the previous section to
eliminate stop marks and ensure a more
even cleaning result.
Caution: Do not use Dirtblaster
on wood surface as it may cause
damage.
House Siding
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
Place detergent suction tube directly into
cleaning solution and apply to surface at
low pressure (for best results, limit your
work area to sections of approximately 6
feet and always apply detergent from
bottom to top). Allow detergent to remain
on surface 1-3 minutes. Do not allow
detergent to dry on surface, if surface
appears to be drying, simply wet down
surface with fresh water.
If needed, use special wash brush
attachment to remove stubborn dirt.
Rinse at high pressure from top to bottom
in an even sweeping motion keeping the
spray nozzle approximately 6 inches from
the cleaning surface.
Caution: Do not use Dirtblaster
on siding as it may cause damage.
Cement Patios,
Brick and Stone
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
Place detergent suction tube directly into
cleaning solution and apply to surface at
low pressure. For best results, limit your
work area to smaller sections of
approximately 25 square feet. Allow
detergent to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure in a sweeping
motion keeping the spray nozzle
approximately 3-6 inches from the cleaning
surface. Always clean from top to bottom
and from left to right. For removing
extremely stubborn stains, use Karcher
Dirtblaster
® nozzle
Cars, Trucks, Boats &
Motorcycles
(with or without detergent)
Pre-rinse vehicle with fresh water. Place
detergent suction tube directly into cleaning
solution and apply to surface at low
pressure. For best results, clean one side of
vehicle at a time and always apply
detergent from bottom to top, do not allow
detergent to dry on surface. If needed use
special wash brush attachment to remove
stubborn dirt. Rinse at high pressure in a
sweeping motion keeping the spray nozzle
approximately 6-8 inches from the cleaning
surface (distance should increase when
rinsing pin-striping or other sensitive
surfaces). Always clean from top to bottom
and from left to right. For best results, wipe
surface dry with a chamois or soft dry
cloth.
Caution: Do not use Dirtblaster
on vehicles as it may cause damage.
® nozzle
® Nozzle.
8
® nozzle