External Serial Interface; Installing The External Serial Interface - Fujitsu PRIMERGY RX300 S3 Options Manual

10

External serial interface

V
CAUTION!
Observe the safety instructions in the
10.1

Installing the external serial interface

Ê Open the server as described in the
I
For standard configuration the external serial interface is to install with a
low profile slot cover. If the optional riser card is used, a standard slot
cover is necessary.
External serial interface in standard configuration
Figure 57: External serial cable with low-profile slot cover.
Ê Remove slot cover 5 ( see
RX300 S3
chapter "Safety notes" on page
chapter "Preparation" on page
"Remove the slot cover" on page
Options Guide
15.
21.
66)
75