Fujitsu PRIMERGY RX300 S3 Options Manual page 11

Introduction Options and upgrade
LocalView module (alphanumeric system display)
The LocalView module provides you with the option of displaying system infor-
mation and hardware system faults alphanumerically. This is an intelligent
module with a micro-controller and its own memory, which functions indepen-
dently of the server system.
The LocalView module consists of an LCD display panel and a toggle switch,
both accommodated in a suitable mount. The mechanical mechanism used
allows the LCD display panel to be pulled out and flapped out. Further infor-
mation on operating the display modes are provided in the documentation on
the LocalView module.
Hard disk drives
The server has two drive cage that can accommodate up to six (2x3) SAS/SATA
hard disk drive modules or up to twelve (2x6) SAS hard disk drive modules.
Each hard disk drive module (HDD module) can accommodate a SAS/SATA or
SAS hard disk drive with a maximum height of 1 inch. The module is connected
to the SAS/SATA backplane without cables. This allows hard disk drive modules
to be simply plugged in or pulled out. (for further details see operating manual).
The hard disk drive system is designed for SAS/SATA with a seperate channel
for each of the hard disk drives.
If the server has a corresponding RAID configuration, defective HDD modules
can also be exchanged online (hot-swap).
Additional controllers in non-hot-plug PCI slots
The system board offers five PCI slots. Slots 1-3 are non-hot-plug PCI slots with
a PCI bus speed of 100 MHz. If slot 1 and slot 2 are not occupied, slot 3 can
work with the PCI bus speed of 133 MHz (IDoubleOP™).
PCI slots 4 and 5 are hot-plug PCI slots which can be equipped with controllers
that have hot-plug capability (the hot-plug PCI slots are described in the
Operating Manual).
Optional riser card
Optionally you can install a Riser card into slot 5, which can be equipped with 3
controllers. The bus speed is 100 MHz. Two slots (6 and 7) can be equipped with
short standard PCI controllers and slot 8 can be equipped with a full length full
height PCI controller.
Options Guide 11
RX300 S3