Installing The Pci Controller In The Riser Card - Fujitsu PRIMERGY RX300 S3 Options Manual

Installing the PCI controller in the riser card

9.2 Installing the PCI controller in the riser card
Ê Open the server as described in the
Figure 51: Removing the riser card
Ê Open the knurled screws.
V
CAUTION!
Keep the rear cover of the PCI slot for future use. If you remove the
controller again and do not replace it with a new one, the rear cover
must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
68
chapter "Preparation" on page
Options Guide
PCI slots
21.
RX300 S3