Chevrolet ranger rt Owner's Manual page 95

HOWTO: Waste Water Dumping
• • Use the dumpsite rinse hose to clean the end of the hose.
• • Replace the big cap onto the end of the waste water hose, twisting it to lock it into
place.
• • Push the blue waste hose back into the waste hose pipe.
• • Once the hose is back in the pipe, replace and tighten the small black plastic cap on
the hose end.
• • Push the waste hose pipe upward until you can swing the flap back over so the hole in
the flap goes over the small rod sticking out of the pipe. Put the R-shaped pin back
through the hole in the end of this rod.
• • Add about ½ gallon of fresh water to the black tank. While you`re doing this, add a
packet of black holding tank chemicals to the tank.
Do not toss the packet into the toilet, even if it claims to be `dissolvable`. It may
not be dissolvable enough for the wastewater system. Tear open the packet and
pour the contents into the toilet, and dispose of the packet in the trash. The contents
of the powder packets can be irritating to your eyes and nose, so hold the packet low
to the bowl and try to pour directly into the tank. Pushing the wastewater pipe
back up - the flap is over the
end, and the pin can now be
put through the hole in the rod.
© 2014 by Roadtrek, Inc.
92