Chevrolet ranger rt Owner's Manual page 88

HOWTO: Potable Water Use
85
You can connect to a city water connection whenever your Roadtrek is not winterized. The city water inlet connection is
located in the small compartment just in front of the driver's side rear tire.
Roadtrek recommends that you use a potable-water hose. These are usually white in color.
City water fill location City water valve in closed (handle Attaching pressure regulator to city
vertical) position water fill location
To connect the Roadtrek's water system to an outside source:
• • Turn the water pump off.
• • Close the city tank fill valve by turning the handle to the vertical position.
• • Close all interior faucets.
• • Flush old water and any contaminants out of the water supply faucet.
• • Connect your fresh water hose to the faucet.
• • Attach your pressure regulator to the Roadtrek's city water connection.
• • Attach a fresh water hose to the the pressure regulator.
• • Slowly open the faucet of the city water source.
• • The city water connection by-passes the water pump and fresh water tank. Therefore, the use of these items is not
necessary when connected directly to an external water source.
© 2014 by Roadtrek, Inc.